Development of a wind retrieval method for low-speed low-pressure flows for ExoMars.

Share on facebook
Share on twitter
Share on linkedin

Soria-Salinas, Á., Zorzano, M. -., Mantas-Nakhai, R., & Martín-Torres, J. (2020). Development of a wind retrieval method for low-speed low-pressure flows for ExoMars. Applied Thermal Engineering, 180 doi:10.1016/j.applthermaleng.2020.115752.

Forced convective heat transfer from three horizontally inclined rectangular-based cylinders (rods) has been studied experimentally under representative Martian near-surface air flows in the Aarhus Wind Tunnel Simulator (AWTS), Denmark. The testing campaign was developed for the HABIT (Habitability: Brines, Irradiation and Temperature) instrument, European payload on board the ExoMars 2022 Kazachok surface platform. The average heat transfer coefficient was determined from steady CO2 flows at a pressure of 9.9 mbar, an ambient temperature of ∼25 °C, and for horizontal free-stream velocities between 0.8 and 12 m/s. A retrieval algorithm to derive the wind speed from the average heat transfer coefficient estimated at each of the three HABIT Air Temperature Sensors (ATS) rods was calibrated within the AWTS. The ATS rods are placed one at the front of the instrument structure (ATS2) and two on the sides (ATS1 and ATS3); and under Martian atmospheric conditions these rods serve as cooling fins. Several relationships between the Nusselt number and the Reynolds and Prandtl numbers reported in the literature were evaluated to model convective heat transfer from the ATS rods. Where needed, corrections to account for radiative heat transfer within the AWTS were implemented. The final retrieval method demonstrated that wind speed can be retrieved for frontal winds in the range of 0–10 m/s, with an error of ±0.3 m/s, using the cooling profile of the ATS rod 3, and for lateral winds in the range of 0–6 m/s, with an error of ±0.3 m/s, using the ATS rod 2 cooling profile.

Otras publicaciones

This website uses cookies to ensure you get the best experience on our website.